![]() So far, the only theory I have is that when doing the switch test, it is testing both inputs at the same time instead of doing them separately. The replacement which I just swapped in place of the one I can't use I am receiving that it is not recognizing one of the inputs or switches and just comes up blank. The installer connected it with a DPP Plus connector. I recently purchased a 9242 to replace one that I was unable to activate. The input is the one by itself on the right. ![]() The lnb has two outputs and one input from another satellite which allows three satellites on each output. Separators cost less than $10.Ī DPP twin is about the same as a DP twin. ![]() You can still run two lines into a dual receiver if you don't have a separator. A DPP separator can NOT be used on two separate receivers. Typically the separator is only a few feet from the receiver. This lnb will allow you to run one line into a DPP separator which has two outputs which go into your dual tuner receiver. It has the switch built in just like the DP twin but has an added feature for dual tuner receivers. Another lnb is the DishPro Plus (DPP) twin.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |